Tandberg Data MSERIES FC USER User Manual page 19

Command
IPAddress
IPDHCP
IPGateway
IPSubnetMask
IsReserved (Immediate)
Description
Sets/displays the current IP address of
the Fibre bridge. If the ipdhcp
command is enabled, the get
command reports the current IP
address assigned by the nameserver.
Enables/disables the capability of the
Fibre bridge to request an IP address
from a DHCP server on the network.
Sets/displays the current default
gateway. If the ipdhcp command is
enabled, the get command reports the
current IP gateway assigned by the
nameserver.
Sets/displays the current subnet mask.
If the ipdhcp command is enabled, the
get command reports the current IP
subnet mask assigned by the
nameserver.
Displays the reservation status of the
current Fibre bridge services session/
interface. When a reserve flag is set,
the configuration image4 is
undergoing modification by another
Fibre bridge services session. Set
commands are unavailable while in
this state. Get commands are available,
however.
Executing a saveconfiguration,
restoreconfiguration, or
firmwarerestart command releases the
reserved state so that other users may
issue set commands.
FC420 Services Software Commands
Tandberg Data FC420 Bridge Option User's Guide
Document T6423053-01, Ver. 1, Rel. 0
Default Syntax
10.0.0.1 set ipaddress xxx.xxx.xxx.xxx
get ipaddress
disabled set ipdhcp [enabled |
disabled]
get ipdhcp
0.0.0.0 set ipgateway xxx.xxx.xxx.xxx
get ipgateway
255.255. set ipsubnetmask
255.0 xxx.xxx.xxx.xxx
get ipsubnetmask
isreserved
November 2002
19