Tandberg Data MSERIES FC USER User Manual page 24

Tandberg Data FC420 Bridge Option User's Guide
Document T6423053-01, Ver. 1, Rel. 0
November 2002
Command
VerboseMode
Virtual Drive Response
XCDevices
XCError
24
Description
Sets the Command Line Interface to
display extended information about a
parameter when the help command is
given. When verbose mode is enabled,
parameter values are generally
preceded by labels in responses to the
get commands. Only the parameter
value is output when verbose mode is
disabled.
Enables/disables the virtual drive
response feature, which allows the
Fibre bridge to provide proxy
responses to SCSI INQUIRY and TEST
UNIT READY commands in the event
of a SCSI device selection time-out or
busy event.
Displays information about the devices
used in a specified Extended Copy
command. The cmdnumber variable is
obtained using the xcstatus
command.
This command returns the following
information: device type, vendor ID,
product ID, serial number, and data
direction.
Retrieves any SCSI sense data returned
by an Extended Copy command as the
result of an error.The cmdnumber
variable is obtained using the xcstatus
command.
This command returns the following
information: SCSI status, sense key,
ASC, and ASCQ. If a device involved
in the command's data transfer also
returned sense data, the device ID
(serial number) along with sense data
for the device will be displayed.
FC420 Services Software Commands
Default Syntax
enabled set verbose [enabled |
disabled]
get verbose
disabled set virtualdriveresponse
[enabled | disabled]
get virtualdriveresponse
get xcdevices [cmdnumber]
get xcerror [cmdnumber]