LED assembly
Warning
Switch off the power and disconnect the power cord.
1.
Open the top cover. Remove the drum/toner cartridges. Place them in
a lightproof black bag to protect the drum units from light and store in a
safe place.
2.
Carefully disconnect the flat data harnesses from the LED assembly by
inserting a small, flat-blade screwdriver through the hole in the end of
the LED assembly and lifting up on the connector. Free the harnesses
from the LED assembly.
3.
Disconnect the LED assembly's power harness from the toner sensor
board.
4.
Push the LED assembly against its springs and rotate the LED assembly
until its locking tabs align with the slots in the frame.
5.
Starting with the front end of the LED assembly, carefully spread the
mounting frame outward slightly to free the LED assembly.
6.
Remove the LED assembly.
Spring
Removing an LED assembly
Reverse these steps to install the LED assembly.
LED Assembly
Top Cover
Spring
Disconnect
Flat Data Harness
Service Guide
0725-52
147