Exit Sensor Assembly; Removing The Exit Sensor Assembly - Xerox 2135N - Phaser Color Laser Printer Quick Reference Manual

Exit sensor assembly

Warning Switch off the power and disconnect the power cord.
1.
Open the top cover. Remove the drum/toner cartridges. Place them in
a lightproof black bag to protect the drum units from light and store in a
safe place.
2.
Remove the fuser exit roller as detailed on page 135.
3. At the engine controller board, disconnect the connector to the exit sensor
assembly (PARTTEMP).
4.
Lift and remove the duplex exit gate.
5. Remove the screw securing the exit sensor assembly.
6.
Guide the sensor's wiring harness through the chassis as you remove
the assembly.
Exit Sensor Assembly

Removing the exit sensor assembly

Reverse these steps to install the exit sensor assembly.
Remove Screw
0725-44
Service Guide 137