Entrance Sensor Board; Removing The Entrance Sensor Board - Xerox 2135N - Phaser Color Laser Printer Quick Reference Manual

Entrance sensor board

Warning Switch off the power and disconnect the power cord.
1.
Remove the multi-sheet bypass feeder as described in the topic on
page 119.
2.
Remove the printer unit chassis as detailed on page 100.
3.
Turning the printer unit chassis upside-down, remove registration roller
assembly B as shown on page 129.
4.
Remove the spring-loaded tray 1 entrance sensor actuator as explained
on page 121. Note the orientation of the actuator's spring for
reassembly.
5.
Remove the two screws securing the entrance sensor board.
6. Remove the board and disconnect the wiring harness from FSNS.
0725-26

Removing the entrance sensor board

Reverse these steps to install the entrance sensor board.
Remove
Screws
Entrance Sensor Board
Service Guide 111