Routing Table - Draytek VIGOR VIGOR2750 User Manual

4 . 1 4 . 2 R o u t i n
4 . 1 4 . 2 R o u t i n
Click Diagnostics and click Routing Table to open the web page.
Destination
Gateway
Genmask
Flags
Metric
Ref
Use
Iface
Refresh
Vigor2750 Series User's Guide
g T a b l e
g T a b l e
Display the IP address for destination network or
destination host.
Display the gateway address or "*" if none set.
Display the netmask for the destination net;
'255.255.255.255' is for a host destination and '0.0.0.0' is
for the default route.
Different codes represent different routing status.
U - route is up.
H - target is a host
G - use gateway
R - reinstate route for dynamic routing
D - dynamically installed by daemon or redirect
M - modified from routing daemon or redirect
A - installed by addrconf
C - cache entry
! - reject route
Display the distance to the target (usually counted in hops).
Display number of references to this route. (Not used in the
Linux kernel.)
Display count of lookups for the route. Depending on the
use of -F and –C, this will be either route cache misses (-F)
or hits (-C).
Display interface to which packets for this route will be
sent.
Click it to reload the page.
233