Table of Contents
Advertisement
Destination Subnet
Source Start Port
Source End Port (optional)
Destination Start Port
Destination End Port (optional) Type a value as the destination end port. Such value will be
Action
3
.
9
.
4
I
P
v
6
R
o
3
.
9
.
4
I
P
v
6
R
o
This page displays the routing table for the protocol of IPv6.
Device
Prefix
Metric
Expires
MTU
Advmss
Hoplimit
Vigor2750 Series User's Guide
u
t
i
n
g
u
t
i
n
g
Type the subnet mask here if you choose Subnet as
Destination IP Type.
Type a value as the source start port. Such value will be
available only TCP/UDP is selected as the protocol.
Type a value as the source end port. Such value will be
available only TCP/UDP is selected as the protocol.
Type a value as the destination start port. Such value will
be available only TCP/UDP is selected as the protocol.
available only TCP/UDP is selected as the protocol.
Set the action that the router will perform for the packets
through the protocol of IPv6.
Accept – If the IPv6 packets fit the condition listed in this
page, the router will let it pass through.
Drop - If the IPv6 packets fit the condition listed in this
page, the router will block it.
Display the interface name (eth0, eth1, fp, etc..)that used to
transfer packets with addresses matching the prefix.
The IPv6 address prefix.
Display the distance to the target (usually counted in hops).
It is not used by recent kernels, but may be needed by
routing daemons.
Display the lifetime of the route.
Display the largest size (in bytes) of a packet.
Display the largest size (in bytes) of an unfragmented piece
of a routing advertisement.
Display the number of network segments on which the
packet is allowed to travel before discarded.
101
Advertisement
Table of Contents
