Connecting Each Receiver To A Phone Line - Dish Network 112182 User Manual

Chapter 4
Installation Instructions

Connecting Each Receiver to a Phone Line

1. Display the
2. Select the
3. Select the
4. Move the highlight to the
Page 102
You must keep each receiver connected to an active telephone line.
Otherwise, you may not be able to order pay per view programs or use all of
the Dish Interactive features. Run a telephone cable with a standard RJ-11
connector from each receiver's back panel PHONE JACK to an active
telephone connection.
You may be able to use a wireless telephone extender. However, this
Note:
may not support all the features of some receivers, such as Caller ID.
: If you have a Digital Subscriber Line (DSL), you may have to install
Note
a DSL filter between the receiver's back panel PHONE JACK and the
telephone wall jack to successfully connect with the DISH Network. You
can obtain a filter from your DSL provider.
You must also set up each receiver for your telephone system (touchtone or
rotary/pulse), and set a telephone number prefix, if you need a prefix to
make an outside call.
Installation and Setup
Telephone System
menu.
Setup
or the
Touch Tone
Usually, you need a telephone number prefix only for business
Note:
installations. For most residential installations, all you need to do is set the
telephone system type. The default setting of
correct dialing. If this is the case, select the
setting, and stop here. If you do need to set a prefix, then instead of
selecting the option, go on to step 4.
Save
button to select the highlighted option.
menu (press MENU then 6-1-4).
option to display the
option in the
Rotary/Pulse
No Prefix needed
Save
list. Press the SELECT
Outside Line Prefix
Telephone System
list.
Phone Type
will allow
option to save the above