Dish Network 112182 User Manual page 90

Chapter 4
Installation Instructions
2. Make sure that the remote control batteries are fresh, and are installed
3. Turn ON the television and receiver.
4. Display the
5. If you Point Dish/Signal screen looks like the one on the left, continue to
6. Enter your ZIP code in the
7. Select the
8. The menu displays the azimuth, elevation, and skew angles. Write down
Azimuth:
Elevation:
9. Select Cancel to exit out of this menu and return to the Point
Skew:
10. Go to Mounting the Dish on page 85.
Page 84
properly. If needed, make sure that the remote is in SAT mode to control the
satellite receiver.
Point Dish and Signal Strength
and then 6-1-1 (unless the receiver already displays this menu).
step 6. If your Point Dish/Signal screen looks like the one on the right,
select .
Peak Angles
option.
Dish 500
these numbers in the blanks provided in the margin.
Dish/Signal menu.
menu by pressing MENU and
field.
ZIP Code