Installing The Receiver In An Existing System - Dish Network Solo 301 User Manual

8. If the screen is not displayed on the TV, press
Point Dish
on the remote control.
9. Select
Check Switch
10. The receiver begins performing the
finished, the
Installation Summary
11. Make sure that the information on the
identifies your system correctly and shows all transponders for all sat-
ellites in your system.
12. Select to go to the
OK
13. Select . An
Cancel
positioning of your dish is complete with a
screen. Select
Point Dish
14. After you select
Yes
upgrade. You will see a
now be downloaded into your receiver. You will also see a status bar
showing the progress of this upgrade.
15. Once the software upgrade is complete, you will see a message that
your receiver's memory is being upgraded.
16. Do not disturb the receiver while the receiver's memory is being
upgraded.
: If you are installing other DISH Pro receivers, be sure to run
Note
Switch on all of them, and allow them to take the necessary software
upgrade.
17. When the memory upgrade is complete, you will either be watching
TV or you will see a message asking you to activate your receiver.
18. If you are asked to activate your receiver, go to page 2 and follow the
instructions.
. When an attention screen displays, select
Check Switch
screen displays.
Installation Summary
screen.
Point Dish
screen will open asking the mounting and
Attention
.
Yes
, the receiver will begin taking a software
that vital program information will
Warning

Installing the Receiver in an Existing System

MENU-6-1-1
Test
tests. When it is
screen
indication in the
Locked
Check
.
Page 21