Dish Network 112182 User Manual page 24

Chapter 2
Parts of the System
TV Set Out
This connection provides good picture quality and good mono
sound quality (even if you have a TV or other devices that
provide stereo sound).
If you use TV S
keep the TV(s) tuned to the same channel (either channel 3 or
4) as you selected on the Channel 3/4 Switch of the satellite
receiver.
The TV S
signal on the TV A
button on the remote control.
TV Antenna/Cable In
Use the TV A
antenna or cable TV box to the receiver. The TV A
C
O
Phono (RCA) Audio/Video Outputs
These outputs provide high-quality picture and stereo
sound.
•
•
Super Video (S-Video) Output
The receiver provides S-Video, which is the highest quality video
available. If you use this output for video, you must still connect
the audio with the P
D
Dolby
The receiver provides Dolby
Pulse Code Modulation (PCM) for an audio amplifier/decoder
that can process this kind of output.
Phone Jack
Connect a phone cable with a standard RJ-11 phone plug to the
receiver here, and then connect the cable to an active phone
jack.
Note
buy Pay Per View programs or use exciting interactive features.
Expansion Port
This port is reserved for future use.
Page 18
O to watch satellite channels, you must
ET UT
O
can be switched between satellite programming and the
ET UT
NTENNA
/C
NTENNA ABLE
I connection is only available through the TV S
ABLE N
as described above.
UT
If the TV has only one input for this type of audio,
connect it to the receiver's R
If you use these outputs to connect the receiver to other devices, be sure
to follow the instructions in the devices' user manuals.
HONO
output.
IGITAL
®
Digital Output
: You must keep the receiver connected to a phone line at all times to
/C I connection using the TV/VIDEO
ABLE N
I to connect a broadcast TV
N
A
output.
IGHT UDIO
(RCA) A O
UDIO UTPUTS
®
Digital encoded output and linear
/
NTENNA
ET
®
or the D
OLBY