Dish Network 112182 User Manual page 98

Dish networks receiver user guide
Table of Contents

Advertisement

Chapter 4
Installation Instructions
2. Make sure the check mark is next to the satellite your dish will be pointed
3. If your
4. Select
Azimuth:
5. Use the number buttons on the remote to enter your ZIP code to get the
Elevation:
6. Mount the dish antenna following the mounting instructions that came with
7. Connect an RG-6 cable from the DishPro S
8. Select
9. When
Page 92
toward.
Point Dish/Signal
step 4. If your
Point Dish/Signal
select
and the
Peak Angles
Peak Angles
.
necessary azimuth and elevation. Write these numbers down in the spaces
provided in the margin.
it.
directly to the DishPro LNBF on the Dish 300.
multi-dish switches between the LNBF and the DishPro receiver.
Check Switch
from the
screen opens, select
Switch
is complete, you will see an
Check Switch
screen similar to the one shown next. It will show a connection ("Conn"
next to satellite) and
Single
an X on the Transponder line. This is okay and does not mean there is a
problem with the system.
screen looks like the one on the left, continue to
screen looks like the one on the right,
option.
Dish 300
I
connection on the receiver
AT
N
Make sure t
Point Dish/Signal
.
Check
Installation Summary
device under 1 (Dish Input). It may also show
here are no
menu. When the
Check

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents