Dish Network 112182 User Manual page 94

Chapter 4
Installation Instructions
10. Attach the LNBF to the Y-bracket using the two LNBF screws.
11. Slide the dish assembly down onto the mast. Make sure the pivot bolt rests
12. You should see the
13. Select
14.
15. When the check switch procedure finishes, you will see an installation
Page 88
below. Be sure there are no multi-dish switches between the LNBF and the
receiver.
on the top of the mast. Turn the dish assembly so that it points in the general
direction of the satellites, using the azimuth angle from 84.
Point Dish/Signal
select System Setup, then Installation, then Point Dish/Signal (press
MENU and then press 6-1-1 on the remote).
. The
Check Switch
or . The receiver shows you a message that it is checking
Select Check Test
the switches. Go to step 15.
summary screen similar to the one below. In the Satellite line, you will see
"Conn." In the Device line, you will "Twin" twice. This indicates that your
receiver has confirmed the connection with your DishPro Twin LNBF is
working. The Transponder line may show two "Xs." This is OK and does
not indicate a problem with the receiver.
P o r t 2
P o r t 1
Connect to Port 1. It's on
the left when the LNBF is
pointed towards you
menu. If not, open the Main Menu,
screen will open.
Check Switch