Dish Network 112182 User Manual page 32

Chapter 2
Parts of the System
Change the Address
Because UHF signals travel long distances and go through walls, a
neighbor's remote could control your receiver by mistake. To handle this
problem, you can change the address on the remote and receiver as follows:
1. Make sure you turn on the TV and receiver.
2. Open the
3. The
4. Press and hold the SAT mode button about three seconds, until
5. Use the number buttons to enter any number from 1 to 16, but
6. Press the POUND (#) button. If you entered the address correctly, the
7. Press the RECORD button.
8. Make sure the
9. To check the address in the remote control, press and hold the SAT
Press the SELECT button to close the
menu.
Page 26
Important System Information
pressing the receiver's front panel SYS INFO button.
Important System Information
.
Remote Address
Write down this number:
all the mode buttons light up, and then let go of the SAT button.
not the one you wrote in step 3.
Write down the number you enter:
SAT mode button flashes three times.
Remote Address
menu now is the same as the one you entered in step 5. If
Information
the addresses are not the same, repeat step 7.
mode button for three seconds. Then, let go of the SAT button, and
press the POUND (#) button twice. The SAT mode button flashes the
same number of times as the address you entered in step 5.
menu by
menu shows a
you see on the
Important System
Important System Information