Dish Network 112182 User Manual page 114

Chapter 5
Reference
E T
VENT IMERS
What's
Happening
You set an event • Maybe you set the timer with the
timer for a wrong frequency.
program that
• Maybe the network changed the
comes on each day
program time.
or each week, but
the timer is either
recording the
wrong program or
sometimes misses
programs.
You set an event Maybe the program time changed so the
timer, but the event timer overlapped another event
timer doesn't work timer.
at all.
You set a Once The program time changed.
event timer, but
the timer doesn't
work at the time
you expect.
You stop an When you stop a repeated event timer,
event timer for one this applies only to the timer's action right
showing of a then.
program that
comes on each day
or each week, but
the timer works
for the next
showing.
You test a VCR • Maybe you didn't turn on the VCR,
code to see if the maybe you didn't put a tape in, maybe
receiver controls a you didn't rewind the tape, or maybe
VCR. The VCR you took the write-protect tab off the
doesn't do the test. tape.
• Maybe the code you're testing doesn't
work for the VCR.
Page 108
What's Wrong What You Can Do
Remember, a Once event timer works just one time for one program, at the
program's actual time. A Mon-Fri event timer works Monday through
Friday on the same channel at the same time, not keyed to any program.
A Daily event timer does the same, Monday through Sunday.
A Weekly event timer works once a week on the same channel at the same
time, not keyed to any program.
If the receiver is on and finds an event timer overlap, it displays the
Event Timer Scheduling Conflict menu. You must edit or delete
one of the overlapping event timers.
A Once event timer always works at the program's actual time.
To stop all actions of a repeated event timer, you must delete the event timer.
Note: The receiver deletes a Once event timer right after it works.
• Make sure you turn on the VCR and put a rewound tape in. Make sure
the write-protect tab is on the tape so that recording is permitted.
• Try another VCR code from the table.