Chapter 3
Using the System
8. To test the device code, highlight the
9. Press the SELECT button to start the test. The VCR records for a few
10. The receiver displays a message that says the VCR test is done. Do what
11. Once you find the right VCR code, select the
12. Set the VCR Event Timer(s) you want.
Use Caller ID
Caller ID displays on your TV the names of people as they call you if you
subscribe to Caller ID from your local phone company.
Enable Caller ID
1. Make sure you have an active phone line connected to the DishDVR
2. Make sure your system is properly grounded. Sometimes an improperly
3. Press MENU on the remote and select
4. When the Caller ID menu opens, move the highlight to Enable and
Page 58
option. The receiver displays a message that
warns you to make sure you turn the VCR on.
seconds, stops, and then rewinds.
the message says. If the VCR did not do the test, enter another device
code from the table, and then do step 8, step 9, and this step again.
option to save the VCR code you entered.
Save
Remember, you must leave the VCR turned on with a blank tape
inserted ready to record.
receiver.
grounded system will cause problems with the Caller ID feature.
then Caller ID, or press MENU-6-1-8 on the remote.
press SELECT to save your choice. Press VIEW to go back to watching
a program.
Test
System Setup
,
Installation
, and