Dish Network 112182 User Manual page 75

Set Up the Remote Control
You can set up the remote to control other devices using the device codes
listed on page 120.
1. Turn the device on.
2. Find the brand name of the
device in the tables starting on
page 120.
3. Press and hold the mode
button until all the other mode
buttons light up, and then let
go of the button.
The mode button flashes.
4. For AUX mode only. Press 0
for a second TV, or 1 for a
second VCR, or 2 for a tuner,
amplifier, or cable box.
5. Enter one of the three-digit
device codes from the table
using the number buttons.
6. If you want to program
limited mode, press 1. If not,
skip to step 7.
7. Press the POUND (#) button.
8. Press the blank POWER
button to turn off the device. If
the device does not turn off,
go to step 10.
9. Turn the device back on and
try some other buttons to
make sure they work. If the
code works for other buttons,
stop here.
10. If the code doesn't work, redo
steps 3 through 9 with another
device code from the tables.
11. If you can't find a code that
works try, Scan for Device
Codes below.
Control Other Devices with the Remote
Use the device's front panel buttons
or its remote control.
If the brand isn't listed, see Scan for
Device Codes on page 70.
For example, hold the TV mode
button for a TV until all of the other
mode buttons light. When you let
go, the TV mode light will flash.
This step is for programming which
kind of device that should be
programmed in AUX mode. If
you're not programming in AUX
mode, skip to step 5.
The three-digit device code should
be for the brand name of your device
that you found in step 2.
See Limited Mode for more
information.
If you entered the code correctly,
the mode button flashes three times.
If the code works, the device should
turn off.
Sometimes the blank POWER
button works when other buttons
don't.
Try every code listed for you brand
until one works for your device.
Page 69 Page 69