Fujitsu 6000NS - fi - Document Scanner Operator's Manual page 388

Screen
Scan Test
360
Message
Load a test page and press the [Scan]
button.
Top cover may be open. Close the top
cover, reload the documents and try
again.
Document not found. Load a docu-
ment into the ADF, making sure the
side guides are adjusted correctly and
try again.
Feed Error: Document(s) may not
match the set paper size, ADF may
have grabbed more than one sheet, or
documents may not be suitable for
scanning. Remove the documents
from the ADF, check them and try
again. If problem persists, consult the
manual.
Paper jam has occurred. Remove the
documents from the ADF and try
again.
Scanner initialization has failed. Try
turning the power off and back on
again. The administrator should con-
tact the FUJITSU scanner dealer or an
authorized FUJITSU scanner service
provider for help.
Action
No action required.
Close the top cover, reload the
documents and try again.
Load the document into the ADF
paper chute, and try again. Load
the document to prevent any space
between the side guides and the
edges of the documents.
For details, refer to "4.1 Loading
Documents" (page 170).
Press the ADF release button to
open the top cover, and remove the
documents from the ADF. If more
than one sheet has been fed, reset
the document and try again.
Check that the actual document(s)
size matches the paper size speci-
fied in the "Paper Size" screen. If
not, specify the paper size again.
For details, refer to "4.8.3 Paper
Size" (page 228).
Try the following:
•
Remove the documents from
the ADF.
•
Remove the pages which were
not scanned correctly.
If the scanner does not restart auto-
matically, try turning the power off
for ten seconds, and back on again.
If the error status persists, contact
your FUJITSU scanner dealer or
an authorized FUJITSU scanner
service provider.