Fujitsu 6000NS - fi - Document Scanner Operator's Manual page 319

A results screen similar to the following should appear:
When checking the network connection status of a server by its IP address, the following results
are possible.
Result
"Ping statistics" shows
"Lost=0 (0% loss)"
"Ping statistics" shows
"Lost=4 (100% loss)"
"Ping statistics" shows
"Lost=N (1 to 99% loss)"
"Hardware error"
OK: Connection is operating normally.
6.3 Network Connection Troubleshooting
Connection
status
OK None
NG Check that the ping target IP address is correct.
If the ping target IP address is correct, refer to
"Failure to connect to a server using its IP
address" (page 298)
NG There may be a quality problem with the LAN
cable. Replace the LAN cable and try again.
In "3.6.12 Checking the Network Operating
Status" (page
Duplex Mode] from "Auto-Negotiation" to a
fixed mode.
NG The LAN cable may have become discon-
nected during the Ping test. Check the status of
the LAN cable and try again.
NG: Connection is faulty.
Network Scanner fi-6000NS Operator's Guide
Action
for further solutions.
124), change the [Link Speed/
6
291