Timeout For Manual Feeding - Fujitsu 5900C - fi - Document Scanner Operator's Manual
Image scanner
Hide thumbs
Also See for 5900C - fi - Document Scanner:
- Getting started (30 pages) ,
- Brochure & specs (2 pages) ,
- Supplementary manual (4 pages)
Table of Contents
Advertisement
8.17 Timeout for Manual Feeding
In manual feeding mode, if the scanner is left without loading the next document to scan for an extended
time period, the scanner completes the scanning once and cancel the manual feeding mode. The time
period is called "timeout".
Configure the settings for the Timeout for Manual as follows:
1.
Start up the Software Operation Panel.
Refer to
"8.1 Scanner Settings" on page
2.
Select the "Timeout for Manual Feeding" setting on the [Device Setting 2]
tab.
3.
Select the timeout period for manual feeding.
You can specify the timeout period by seconds. Scanning will be complete when the specified
time period has elapsed after the last sheet of paper was loaded onto the Hopper.
Select a timeout period from the following:
5, 10, 20, 30, 40, 50, 60, 70, 80, 90, 100, 110 (seconds)
HINT
166.
For details on how to scan the document manually, refer to
Documents Manually" on page 34
8.17 Timeout for Manual Feeding
8
"2.12 Feeding
193
Advertisement
Table of Contents
