Fujitsu 5900C - fi - Document Scanner Operator's Manual page 190

Page edge filler
Fill the end sections of a specified-
(Automatic paper mm-wide with white when the
size detection) paper size is automatically
detected.
The end sections of a specified-
mm-wide are filled with white.
Document check Specify the area to be detected for
area specifica- multifeed. You can select left, mid-
tion for Multifeed dle, or right for detection.
Detection Refer to
tion" on page
- Modes of selec- Specify which area to check for
tion multifeed: The area for which mul-
tifeed detection is enabled or the
area for which multifeed detection
is disabled.
Refer to
tion" on page 175.
- Specify area Specify the range where multifeed
detection is enabled/disabled.
Refer to
tion" on page 175.
Thin Paper Mode To scan thin paper documents,
enable this mode.
Paper Jam Specify the degree of jam detection
Detection at the feeder.
AutoCrop Bound- Select Round Up or Round Down:
ary The fractional figures can be
rounded up or down when the paper
size is automatically detected.
SCSI Bus Width Specify the data transfer width for
SCSI connection.
Auto Color Specify the slice level for automati-
Detection cally detecting Color/Monochrome
Prepick To give a higher priority to process-
ing speed, select [Yes], if not,
select [No].
170
8.1 Scanner Settings
"8.4 Multifeed Detec-
175.
"8.4 Multifeed Detec-
"8.4 Multifeed Detec-
Top/Left/Right/Bottom: 0 to 7.5mm
(can be set in increments of 0.5mm)
A
(A: Image area B: Filled area
A+B: Area to be output)
Left/Middle/Right
Non-detection area/Detection area
Start: 0 - 550mm
End: 0 - 550mm
Disable/enable
Normal/Sensitivity low
Round Up/Round Down
16-bit (wide)/8-bit
0 to 255 (steps)
Yes/No
Top/Bottom/
Left/Right:
0mm
B
Left
Start/End: 0mm
Disable
Sensitivity-Low
Round Down
16-bit
5
Yes