Device Setting - Fujitsu 5900C - fi - Document Scanner Operator's Manual

■ Settings
Using the Software Operation Panel, you can configure the following settings for the scanner connected to
the PC.
［Device setting］
Item
Page counter For evaluating the consumable
(Consumables
replacement cycle.
counter)
Use this function to reset the counters
after replacing consumables.
Refer to
Replacement Cycle" on page 116
Power saving Select the waiting time before entering
setting the Power saving mode.
Refer to
on page 172
Offset setting Adjust the start position for the docu-
ment scanning.
Refer to
page 173
Scan scale Adjust the magnification in the feed-
ing direction.
Refer to
page 173
168
8.1 Scanner Settings
Explanation
"5.1 Consumables and
"8.2 Power saving setting"
"8.3 Offset/Scan scale" on
"8.3 Offset/Scan scale" on
Selectable parameter
Pad/Pick roller/Separator Roller/Brake
roller
remaining ink level (only for the
imprinter option)
Setting range 15 to 55 minutes (set in
steps of 5 min.)
Left right: setting range -2 to 3mm
(set in 0.5mm steps)
Up down: setting range -2 to 3mm (set
in steps of 0.5mm)
Setting range -6.3% to 6.3% (set in
0.1% steps)
Default
-
15 min.
left right
0mm
up down
0mm
0%