Table of Contents
Advertisement
Menu item
Portrait Width
3–48 inches
76–1219 mm
Portrait Height
3–48 inches
76–1219 mm
Feed Direction
Short Edge
Long Edge
Bin Setup menu
Menu item
Output Bin
Standard Bin
Bin [x]
Configure Bins
Mailbox
Link
Link Optional
Type Assignment
Description
Sets the portrait width
Notes:
•
11.69 inches is the US factory default setting. Inches can be increased
in 0.01-inch increments.
•
296.9 mm is the international factory default setting. Millimeters can
be increased in 1-mm increments.
•
If the width exceeds the maximum, then the printer uses the maximum
width allowed.
Sets the portrait height
Notes:
•
48 inches is the US factory default setting. Inches can be increased in
0.01-inch increments.
•
1219 mm is the international factory default setting. Millimeters can
be increased in 1-mm increments.
•
If the height exceeds the maximum, then the printer uses the
maximum height allowed.
Specifies the feed direction
Notes:
•
Short Edge is the factory default setting.
•
Long Edge appears only if the longest edge is shorter than the
maximum width supported by the tray.
Description
Specifies the default exit bin
Note: Standard Bin is the factory default setting.
Specifies configuration options for exit bins
Notes:
•
Mailbox is the factory default setting. This setting
treats each bin as a separate mailbox.
•
Link configures all available bins as one large exit bin.
•
Link Optional links together all available exit bins
except the standard bin and only appears when at least
two optional bins are installed.
•
Type Assignment assigns each paper type to an output
bin or linked bin set.
•
Bins assigned the same name are automatically linked
unless Link Optional is selected.
Understanding printer menus
112
Advertisement
Table of Contents
Troubleshooting
