Lexmark 22Z0000 User Manual page 136

Menu item
Alarms
Alarm Control
Cartridge Alarm
Staple Alarm
Hole Punch Alarm
Timeouts
Standby Mode
1–240
Disabled
Timeouts
Sleep Mode
2–240 min
Disabled
Timeouts
Screen Timeout
15–300 sec
Timeouts
Print Timeout
Disabled
1–255 sec
Description
Sets an alarm to sound when the printer requires operator
intervention
Available selections for each alarm type are:
Off
Single
Continuous
Notes:
•
Single is the factory default setting for Alarm Control and
Cartridge Alarm. Single sounds three quick beeps.
• Off is the factory default setting for Staple Alarm and Hole
Punch Alarm. Off means no alarm will sound.
• Continuous repeats three beeps every 10 seconds.
Specifies the number of minutes of inactivity before the system
enters a lower power state
Note: 15 minutes is the factory default setting.
Sets the amount of time the printer waits, after a print job is
finished, before it goes into a reduced power state
Notes:
•
30 minutes is the factory default setting.
•
Lower settings conserve more energy, but may require
longer warm-up times.
•
Select the lowest setting if the printer shares an electrical
circuit with room lighting.
•
Select a high setting if the printer is in constant use. Under
most circumstances, this keeps the printer ready to print
with minimum warm-up time.
Sets the amount of time in seconds the printer waits before
returning the printer display to a Ready state
Note: 30 seconds is the factory default setting.
Sets the amount of time in seconds the printer waits to receive
an end-of-job message before canceling the remainder of the
print job
Notes:
•
90 seconds is the factory default setting.
• When the timer expires, any partially printed page still in
the printer is printed, and then the printer checks to see if
any new print jobs are waiting.
•
Print Timeout is available only when using PCL emulation.
This setting has no effect on PostScript emulation print
jobs.
Understanding printer menus
136