Too Many Disks Installed; Too Many Flash Options Installed; Too Many Trays Attached - Lexmark 22Z0000 User Manual

56 USB port [x] disabled
Try one or more of the following:
•
Touch Continue to clear the message.
The printer discards any data received through the USB port.
•
Make sure the USB Buffer menu is not set to Disabled.
57 Configuration change, some held jobs were not restored
Something has changed in the printer to invalidate the held jobs. Possible changes include:
•
The printer firmware has been updated.
•
Paper input options needed for the print job were removed.
• The print job was created using data from a device in the USB port and the device is no longer in the USB port.
•
The printer hard disk contains print jobs that were stored while installed in a different printer model.
Touch Continue to clear the message.

58 Too many disks installed

1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Remove the excess disks.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.

58 Too many flash options installed

1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Remove the excess flash memory.
4
Connect the power cord to a properly grounded outlet.
5
Turn the printer back on.

58 Too many trays attached

1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Remove the additional trays.
4
Connect the power cord to a properly grounded outlet.
5
Turn the printer back on.
Troubleshooting
213