Juniper JUNOSE 11.2.X IP SERVICES Configuration Manual page 326

JunosE 11.2.x IP Services Configuration Guide
show l2tp destination profile
300
TransformSet—Transform set(s) configured for the profile
Pfs group—PFS group configured for the profile; 0 (zero) means that PFS is not
configured for the profile
Local ip address—Local endpoint address
Example 1
host1:vr11#show ipsec transport profile
IPSEC transport profile goi1
IPSEC transport profile goi2
2 Ipsec transport profiles found
Example 2
host1:vr11#show ipsec transport profile goi1
IPSEC transport profile goi1
Virtual router vr00
Peer address 10.255.0.62
Application gre,dvmrp
Lifetime range in seconds 900 900
Lifetime range in kilobytes 102400 4294967294
TransformSet transport-esp-3des-sha1
Pfs group 0
Local ip address : 10.255.0.61
See show ipsec transport profile.
Use to display configuration information for an L2TP destination profile and its
associated L2TP host profiles.
If single-shot tunnels are configured for a particular host profile, the command displays
this information as an attribute of the profile for that remote host.
Field descriptions
Destination profile attributes:
Transport—Method used to transfer traffic
Virtual router—Name of the virtual router
Peer address—IP address of the LAC
Destination profile maximum sessions—Maximum number of sessions allowed
for the destination profile
Destination profile current session count—Number of current sessions for the
destination profile
Host profile attributes:
Remote host is—Name of the remote host
Tunnel password is—Password for the tunnel
Copyright © 2010, Juniper Networks, Inc.