Juniper JUNOSE 11.2.X IP SERVICES Configuration Manual page 284

JunosE 11.2.x IP Services Configuration Guide
profile
tunnel checksum
tunnel destination
258
Use to configure a destination profile for dynamic GRE tunnels.
Use the any-virtual-router keyword to create a default destination profile for all virtual
routers. There can only be one default destination profile defined in the system.
Use the virtual-router keyword to specify a specific transport virtual router.
Example
host1(config)#gre destination profile kanata2
Use the no version to delete the destination profile.
See gre destination profile.
Use to assign an IP profile with parameters that are used to stack an upper IP interface
over a dynamic GRE or DVMRP tunnel to the destination profile.
Example
host1(config-dest-profile)#profile ip-kanata
Use the no version to remove the profile assignment from the destination profile.
See profile.
Use to enable checksum computation across a GRE tunnel.
Checksum computation is not supported for DVMRP tunnels.
Selecting this feature causes the E Series router to drop corrupted packets it receives
on the tunnel interface.
Example
host1(config-dest-profile)#tunnel checksum
Use the no version to disable the checksum option.
See tunnel checksum.
Use to configure the remote end of the tunnel.
Specify the IP address of an interface on the remote router or the range of destination
addresses:
Use the subnet keyword to configure the IP address for the destination interface
and the mask.
Use the range keyword to configure the first IP address and the last IP address of
the destination interface range
Example 1—Specifies an IP address and mask for the destination interface
host1(config-dest-profile)#tunnel destination subnet 192.13.7.1 255.0.0.0
Example 2—Specifies a range of IP addresses for the destination interface
Copyright © 2010, Juniper Networks, Inc.