Juniper JUNOSE 11.2.X IP SERVICES Configuration Manual page 224

JunosE 11.2.x IP Services Configuration Guide
show l2c
198
Use to display the configured values for the adjustment factor applied to the upstream
data rate and downstream data rate reported by ANCP for each DSL type. The
adjustment factor is used to generate an accurate QoS shaping rate.
Field descriptions
L2C QoS Adjustment Rates—List of all DSL types and the corresponding adjustment
factor for each
ADSL1—Adjustment factor for the ADSL1 DSL type
ADSL2—Adjustment factor for the ADSL2 DSL type
ADSL2+—Adjustment factor for the ADSL2+ DSL type
VDSL—Adjustment factor for the VDSL DSL type
VDSL2—Adjustment factor for the VDSL2 DSL type
SDS—Adjustment factor for the SDS DSL type
Example 1—Displays the adjustment factor for each DSL type
host1#show adjustment-factor
L2C QoS Adjustment Rates:
ADSL1: 45
ADSL2: 55
ADSL2+: 100
VDSL: 100
VDSL2: 55
SDS: 100
Example 2—Displays the adjustment factor for a specific DSL type verification criteria
host1#show adjustment-factor vdsl2
VDSL2:11
See show adjustment-factor.
Use to display information about the ANCP configuration on the router.
Field descriptions
Current timeout—Configured session timeout (in seconds)
Qos adaptive mode—Whether QoS adaptive mode is enabled (true) or disabled
(false)
Wait-for-gsmp-syn—Whether learning is enabled or disabled
gsmp-syn-timeout—Configured TCP session timeout (in seconds)
Example
host1#show l2c
L2C:
Current session timeout: 25 seconds
Qos adaptive mode: false
Copyright © 2010, Juniper Networks, Inc.