Table of Contents
Advertisement
JunosE 11.2.x IP Services Configuration Guide
266
packets—Number of packets received or transmitted by the tunnel
octets—Number of octets received or transmitted by the tunnel
discards—Number of packets not accepted by the tunnel
Errors—Number of packets with errors received or transmitted by the tunnel
Data rx—Received data
Data tx—Transmitted data
Tunnels found—Total number of GRE tunnels found
Tunnels were created dynamic—Number of tunnels created dynamically
Example 1—Displays three dynamic GRE tunnels
host1:vr11#show gre tunnel
GRE tunnel mobileIp-dynamic-1 is Up
GRE tunnel mvpn-dynamic-2 is Up
GRE tunnel mvpn-dynamic-3 is Down
3 GRE tunnels found
3 tunnels were created dynamic
Example 2—Displays the detail of a dynamically created GRE tunnel for the data MDT
application
host1:vr11#show dvmrp tunnel detail mvpn-dynamic-1
GRE tunnel mvpn-dynamic-1 is Up
tunnel is dynamic
Application is MVPN
Tunnel operational configuration
Tunnel mtu is '5000'
Tunnel source address is '1.1.1.1'
Tunnel destination address is '2.2.2.2'
Tunnel transport virtual router is vr1
Tunnel mdt is disabled
Tunnel checksum option is disabled
Tunnel sequence number option is disabled
Tunnel up/down trap is enabled
Tunnel-server location is 4/0
Tunnel administrative state is Up
Statistics
packets
Data rx
0
Data tx
0
1 GRE tunnel found
1 tunnel was created dynamically
Example 3—Displays the detail of a dynamically created GRE tunnel for the Mobile IP
application
host1:vr12#show gre tunnel detail mobileIp-dynamic-1
GRE tunnel mobileIp-dynamic-1 is Up
tunnel is dynamic
Application is Mobile-IP
Tunnel operational configuration
octets
discards
0
0
0
0
Copyright © 2010, Juniper Networks, Inc.
errors
0
0
Advertisement
Table of Contents
