Juniper JUNOSE 11.2.X IP SERVICES Configuration Manual page 283

dvmrp destination profile
enable ipsec-transport
gre destination profile
Copyright © 2010, Juniper Networks, Inc.
Configure a destination profile for DVMRP.
1.
host1(config-dest-profile)#dvmrp destination profile kanata1 virtual-router vr1
Set the source address for the tunnel.
2.
host1(config-dest-profile)#tunnel source 1.1.1.1
Set the destination address for the tunnel.
3.
host1(config-dest-profile)#tunnel destination subnet 10.0.0.0 255.0.0.0
(Optional) Set the maximum transmission unit (MTU) size for the tunnel.
4.
host1(config-dest-profile)#tunnel mtu 10240
(Optional) Configure an IP profile with parameters that are used to stack an upper
5.
IP interface over a dynamic DVMRP tunnel.
host1(config-dest-profile)#profile ip-kanata
(Optional) Enable IPSec transport mode.
6.
host1(config-dest-profile)#enable ipsec-transport
(Optional) Create a multicast VPN tunnel.
7.
host1(config-dest-profile)#tunnel mdt profile kanata-mdt
Use to configure a destination profile for dynamic DVMRP tunnels.
Use the any-virtual-router keyword to create a default destination profile for all virtual
routers. There can only be one default destination profile defined in the system.
Use the virtual-router keyword to specify a specific transport virtual router.
Example
host1(config)#dvmrp destination profile kanata1
Use the no version to delete the destination profile.
See dvmrp destination profile.
Use to specify that the router accepts only dynamic IP tunnels protected by an IPSec
transport connection.
This command is supported in the destination profile only when you have installed an
ISM on ERX routers.
Example
host1(config-dest-profile)#enable ipsec-transport
Use the no version to disable IPSec transport mode.
See enable ipsec-transport.
Chapter 10: Configuring Dynamic IP Tunnels
257