Juniper JUNOSE 11.2.X IP SERVICES Configuration Manual page 272

JunosE 11.2.x IP Services Configuration Guide
show dvmrp tunnel summary
246
host1#show dvmrp tunnel detail
DVMRP tunnel boston1 is up (tunnel is static)
Tunnel operational configuration
Tunnel name is 'boston1'
Tunnel mtu is '10240'
Tunnel source address is '0.0.0.0'
Tunnel destination address is '0.0.0.0'
Tunnel transport virtual router is vr1
Tunnel up/down trap is enabled
Tunnel server location is 4/0
Tunnel secured by ipsec transport interface 1
Tunnel administrative state is up
Statistics packets
Data rx 0
Data tx 0
1 DVMRP tunnel found
1 tunnel was created static
Example 3
host1#show dvmrp tunnel state enabled
DVMRP tunnel boston1 is up
1 DVMRP tunnel found
1 tunnel was created static
Example 4
host1#show dvmrp tunnel virtual-router vr1 ip 0.0.0.0
DVMRP tunnel boston1 is up
1 DVMRP tunnel found
1 tunnel was created static
Example 5—Displays a DVMRP tunnel on an E320 router
host1#show dvmrp tunnel detail
DVMRP tunnel v1Tunnel1 is Up (tunnel is static)
Tunnel operational configuration
Tunnel mtu is '10240'
Tunnel source address is '50.1.1.1'
Tunnel destination address is '50.1.1.2'
Tunnel transport virtual router is v1
Tunnel up/down trap is enabled
Tunnel-server location is 13/0/0
Tunnel administrative state is Up
Statistics packets
Data rx 5
Data tx 5
See show dvmrp tunnel.
Use to display a summary of information about DVMRP tunnels.
Field descriptions
Administrative status
enabled—Tunnel is available for use
disabled—Tunnel is not available for use
octets discards
0 0
0 0
octets
740
740
Copyright © 2010, Juniper Networks, Inc.
errors
0
0
discards errors
0 0
0 0