Table of Contents
Advertisement
JUNOSe 10.0.3 Release Notes
PPPoE
QoS
Service Manager
SRC Software and SDX Software
Unified ISSU
54
Resolved Known Problems
When many PPPoE subscribers were attempting to reconnect on a line
module, the RADIUS server experienced an outage. Some of the subscribers
were unable to reconnect. Some subscribers recieved PADRs but no PADS
could be sent. [Defect ID 90216]
ES2 10G LM in slot 0 crashed - reset type: panic arg (0xda) file: templateRam.cc
line: 305 [Defect ID 90093]
When you activate independent IPv4 and IPv6 services for a subscriber session
on an IPv4 interface, although the IPv6 service is activated, it is not deleted and
stops responding when the subscriber logs out of the session. Similarly, when
you activate independent IPv4 and IPv6 services for a subscriber session on an
IPv6 interface, although the IPv6 service is activated, it is not deleted and stops
responding when the subscriber logs out of the session.
This problem might occur if there is a mismatch between the configured
service and the interface associated with the subscriber. For example, this
problem might occur when you try to provision an IPv4 service on an IPv6
interface. This problem is also observed only when Service Manager support
for combined or independent IPv4 and IPv6 services is available in JUNOSe
Software. [Defect ID 181626]
Partial activation of subscriber service sessions occurs in a dual stack of
combined or independent IPv4 and IPv6 services, even when an invalid
Ascend-Data-Filter attribute is returned from the RADIUS server. This problem
occurs only when both the following conditions are satisfied: [Defect ID
181500]
Service Manager supports combined, or independent, IPv4 and IPv6
services in a dual stack
Both the Activate-Service and Ascend-Data-Filter VSAs are passed from the
RADIUS server.
Problem with re-attaching policies on SDX managed DSI interfaces after a line
module reload. [Defect ID 87326]
Slot-7 SRP reset type: processor exception 0x700 (program); task:
sssClient_Data_1 [Defect ID 89863]
When L2TP is configured to use the silent failover method for peer
resynchronization and the tunnel endpoints are reachable using an IGP
distributed route, unified ISSU fails if the IGP reconvergence time exceeds the
maximum retransmission retry time for L2TP. [Defect ID 180769]
Advertisement
Table of Contents
