Known Problems And Limitations; Aaa; Ancp; Arp - Juniper JUNOSE 10.0.3 - RELEASE NOTES 4-30-2010 Release Note

Known Problems and Limitations

AAA

ANCP

ARP

ATM

When a mirror rule that triggers on username is employed for packet mirroring
of dynamic IP subscribers over ATM, removal of the rule does not disable
packet mirroring. [Defect ID 175356]
Work-around: Use a mirror rule that triggers on account session ID rather than
on username.
On an E320 router that has established 3000 ANCP adjacencies with a client
and traffic is initiated, the following behavior occurs sporadically: All existing
Telnet sessions are disconnected and no new Telnet sessions can be
established for several minutes. [Defect ID 83872]
The ES2 4G LM can reset during a unified in-service software upgrade after you
issue the issu start command on a router configured with 8000 dynamic VCs
and 8000 packet-triggered dynamic subscriber interfaces. [Defect ID 86761]
When one or more ATM1483 attributes appears in a profile, the show
configuration include-defaults command fails to display the default values for
all possible ATM1483 attributes. [Defect ID 67157]
When 16,000 PPPoA interfaces are configured on an OCx/STMx ATM line
module paired with an OC3-4 I/O module in an ERX-14xx model, ERX-7xx
model, or ERX-310 router, PING traffic passing through the line module on the
restarting router experiences an outage of 103 seconds, which is beyond the
maximum limit, after a unified ISSU from JUNOSe Release 9.2.0p1-0 to
9.3.0b0-12. This outage does not occur when the same configuration is applied
on a Gigabit Ethernet interface. [Defect ID 179794]
ATM line modules reset after unified ISSU completes at the LAC when an
MLPPP bundle with three links are tunneled to the LNS. [Defect ID 178821]
Unified ISSU is not supported when ILMI is configured on ATM interfaces.
[Defect ID 176007/177122 ]
The line module resets when you issue the show nbma arp command after you
have configured NBMA interfaces on an ATM line module. [Defect ID 88491]
When you perform an snmpWalk on the juniAtmSubIfVccTable, a response is
received for only a few of the total configured ATM subinterfaces when both of
the following are true: the router has a line module that has some ATM-related
configuration and the line module is in the disabled state. [Defect ID 80020]
Release 10.0.3
Known Problems and Limitations
35