Cli - Juniper JUNOSE 10.0.3 - RELEASE NOTES 4-30-2010 Release Note

CLI

If the router is under a heavy load, the show profile command might take
longer than usual to execute.
Work-around: You can either delay examination of profiles until the router is
less busy, or save a copy of the profile to a text file off the router.
In Interface Configuration mode for a major interface, the CLI displays options
for protocols that are not supported by that interface type.
When you issue the reload command on an ERX310 router, the command
might display a warning message that erroneously indicates that a
synchronizing operation will be performed. Any references to synchronization
that appear in command output or system messages do not apply to the
ERX310 router, which does not support SRP module redundancy.
The following commands have been deprecated in the JUNOSe Software and
might be removed completely in a future release. If a command has been
deprecated for only a particular command mode, the table specifies any modes
for which it is still available.
Deprecated Command
aaa accounting interval
cablelength short
clock rate
channel-group description
channel-group shutdown
channel-group snmp trap link-status Controller Configuration
channel-group timeslots
classifier-list
color
controller e1
controller t1
description
fdl
fdl carrier
fdl string
fdl transmit
filter
Command Mode
Global Configuration
Controller Configuration
Interface Configuration
Controller Configuration
Controller Configuration
Controller Configuration
Global Configuration
Policy List Configuration
Global Configuration
Global Configuration
Interface Configuration
Still available in Controller
Configuration and VRF
Configuration modes
Controller Configuration
Controller Configuration
Controller Configuration
Controller Configuration
Policy List Configuration
Release 10.0.3
Preferred Command
aaa service accounting
interval and
aaa user accounting interval
ip classifier-list
color in Classifier Group
Configuration mode
ip description
filter in Classifier Group
Configuration mode
Known Behavior
13