Table of Contents
Advertisement
JUNOSe 10.0.3 Release Notes
Unified ISSU
Unsupported Features
E120 Router and E320 Router
Multicast
8
Unsupported Features
host1(config)#no ip dhcp-local limit pos
To display the maximum number of IP address leases available for POS access
interfaces, use the existing show ip dhcp-local limits command. For example:
host1#show ip dhcp-local limits
*****************************************
DHCP Local Server Address Limits
ATM Limit
- 48000
VLAN Limit
- 48000
POS Limit
- 1000
Ethernet Limit - 48000
Service Manager Support for Unified ISSU
Service Manager support for unified ISSU is limited in this release to early field
trial purposes only.
The JUNOSe Release 10.0.x documentation set describes some features that are
present in the code but that have not yet been fully qualified by Juniper Networks.
If you use any of these features before they have been fully qualified, it is your
responsibility to ensure that the feature operates correctly in your targeted
configuration.
The following features are present but unsupported in this release.
The ES2 10G LM and ES2 10G Uplink LM do not support layer 2 statistics for
VLANs.
Subscriber Interfaces on the ES2 10G Uplink LM
You can configure dynamic subscriber interfaces and static subscriber
interfaces on the ES2 10G Uplink LM using the CLI. However, configuring
subscriber interfaces on the ES2 10G Uplink LM provides no benefit because
access features such as per-subscriber QoS are unavailable on the module.
Unsupported IPv6 Data MDT Commands in CLI
The ipv6 pim data-mdt command and the show ipv6 pim data-mdt
command are unsupported in the current release.
The IPv6 PIM Data MDT Configuration mode is unsupported in this release. The
following commands appear in IPv6 PIM Data MDT Configuration mode but are
unsupported in the current release:
ipv6 pim join-filter
mdt-data-timeout
Advertisement
Table of Contents
