Juniper JUNOSE 10.0.3 - RELEASE NOTES 4-30-2010 Release Note page 71

Release 10.0.3
JUNOSe Broadband Access Configuration Guide, Chapter 2, Monitoring and
Troubleshooting Remote Access, fails to include the following information for the
output of the show radius servers command:
If a RADIUS server was never configured on the virtual router, the command
displays the following message:
host1#show radius servers
no radius servers configured
If a RADIUS server was configured previously and then removed on the virtual
router, the command displays the following information:
host1#show radius servers
RADIUS Authentication Configuration
-----------------------------------
Monitoring RADIUS Server Information ¦ 1
Udp Retry Maximum Dead
IP Address Port Count Timeout Sessions Time Secret Status
------------- ---- ----- ------- -------- ---- ------ ------
RADIUS Accounting Configuration
-------------------------------
Udp Retry Maximum Dead
IP Address Port Count Timeout Sessions Time Secret Status
------------- ---- ----- ------- -------- ---- ------ ------
RADIUS Pre-Authentication Configuration
---------------------------------------
Udp Retry Maximum Dead
IP Address Port Count Timeout Sessions Time Secret Status
------------- ---- ----- ------- -------- ---- ------ ------
RADIUS Route-Download Configuration
-----------------------------------
Udp Retry Maximum Dead
IP Address Port Count Timeout Sessions Time Secret Status
------------- ---- ----- ------- -------- ---- ------ ------
The description of the bgp graceful-restart command in the JUNOSe Command
Reference A to M incorrectly states that graceful restart is enabled by default. It
also erroneously states that using the default keyword with the bgp
graceful-restart command restores the default condition, wherein graceful
restart is enabled. The correct default behavior of BGP graceful restart is that it
is disabled, which prevents the advertisement of all BGP graceful restart
capabilities. This default behavior has been applicable since the time this
command was introduced.
In addition, the Note in this command section inaccurately states that the E
Series router supports graceful restart only as a receiving peer and not as a
restarting peer. However, E Series routers have supported graceful restart as
restarting peers, in addition to functioning as receiving peers, since JUNOSe
Release 5.1.0.
63
Errata