Table of Contents
Advertisement
BFD
Bridged Ethernet
CLI
DHCP
The output of the show atm arp command displays only 4096 entries when
the line module is configured with more than 4096 NBMA ARP entries. [Defect
ID 68849]
After you have shut down the interface to the next hop (for the route that is
used to establish the BFD session), output for the show bfd session command
erroneously indicates the shutdown interface as Management Interface
(FastEthernet 6/0). [Defect ID 174271]
The CLI erroneously permits you to configure bridge1483 encapsulation over
AAL5MUX IP even though that configuration is not supported. [Defect ID
35013]
When you issue a run show ppp command, the CLI changes the configuration
level of the command line to Global Configuration mode rather than remaining
at the level from which you issued the command. [Defect ID 52165]
Work-around: Reissue the commands necessary to reenter the desired mode.
The logout subscribers all command may not log out all of the DHCP
subscribers. Although the bindings and DHCP addresses are cleared, the show
subscribers summary command may display some of the DHCP subscribers.
[Defect ID 180176]
Work-around: Try using the dhcp delete-binding all command. If this does
not clear the subscribers, you may want to reload the line module to avoid
further issues.
You cannot paste a load-rebalance command string that uses the percent
option into a console or Telnet session from show configuration output
because the output displays the % sign rather than the percent keyword that
was submitted with the command and the percent sign is not recognized by
the CLI. [Defect ID 81705]
DHCP NAK packets are sent from a different VLAN than the one on which the
renew request is received on a router that is configured with dynamic VLANs,
DHCP local server, and automatically created dynamic subscriber interfaces.
This behavior occurs only after a link flap has taken place. [Defect ID 87062]
DHCP packets are not forwarded to the DHCP server over dynamically created
interfaces when all of the following are true: [Defect ID 180343]
DHCP relay or DHCP relay proxy is configured on the router.
The client-facing interfaces are created dynamically using bridged Ethernet
over static ATM PVCs.
Release 10.0.3
Known Problems and Limitations
37
Advertisement
Table of Contents
