Juniper JUNOSE 10.0.3 - RELEASE NOTES 4-30-2010 Release Note page 14

JUNOSe 10.0.3 Release Notes
6
Release Overview
Task
Install the router
Learn about modules
Get up and running quickly
Configure the router
Configure physical layer interfaces
Configure link layer interfaces
Configure IP, IPv6 and Neighbor
Discovery, and interior gateway
protocols (RIP, OSPF, and IS-IS)
Configure IP routing services,
including routing policies, NAT, J-Flow
statistics, BFD, IPSec, digital
certificates, IP tunnels, and VRRP
Configure IP multicast routing and
IPv6 multicast routing
Configure BGP, MPLS, Layer 2 service,
and related applications
Configure policy management
Configure quality of service (QoS)
Configure remote access
Get specific information about
commands
Monitor system events
Look up definitions of terms used in
JUNOSe technical documentation
Document
ERX Hardware Guide
E120 and E320 Hardware Guide
ERX Module Guide
ERX End-of-Life Module Guide
E120 and E320 Module Guide
E Series Installation Quick Start poster or ERX Quick Start
Guide
E120 and E320 Quick Start Guide
JUNOSe System Basics Configuration Guide
JUNOSe Physical Layer Configuration Guide
JUNOSe Link Layer Configuration Guide
JUNOSe IP, IPv6, and IGP Configuration Guide
JUNOSe IP Services Configuration Guide
JUNOSe Multicast Routing Configuration Guide
JUNOSe BGP and MPLS Configuration Guide
JUNOSe Policy Management Configuration Guide
JUNOSe Quality of Service Configuration Guide
JUNOSe Broadband Access Configuration Guide
JUNOSe Command Reference Guide A to M
JUNOSe Command Reference Guide N to Z
JUNOSe System Event Logging Reference Guide
JUNOSe Glossary