Table of Contents
Advertisement
JUNOSe Command Reference Guide Update
sscc update-policy-request enable
Description
Syntax
Mode
Release Information
Appendix C: Transferring DSL Line Rate Information from an Access Node to SRC Software
NOTE:
Only the field that has been newly added by this feature in the output of the
show sscc info command is described here. For a complete version of the
descriptions of all the other fields that are displayed in the output of this
command, see JUNOSe Broadband Access Configuration Guide, Chapter 2,
Monitoring and Troubleshooting Remote Access.
This section supplements the JUNOSe Command Reference Guide N to Z. It describes
the new command that enables the E Series router that functions as the SRC client
to retrieve changed DSL line rate information from ANCP and report this
information to the COPS server.
Configures the router to collect updated DSL line rate parameters from an access
node using the ANCP topology discovery message and transmit the information to
the COPS server with corresponding COPS messages. If you enable this feature, the
access node sends line rate parameters not only during connection establishment,
but also whenever any of the line rate values changes after the connection is built.
The no version restores the default, which disables line rate parameters to be sent
to the COPS server.
NOTE:
When you configure the sscc update-policy-request enable command, a
warning message is displayed, prompting you to confirm whether you want to
enable the router that functions as the SRC client to forcibly send updated line rate
information parameters to the COPS server, which is running a release of SRC
software earlier than Release 3.0.0 that is not compatible with the line rate
message format.
[ no ] sscc update-policy-request enable
Global Configuration
Command introduced in JUNOSe Release 9.3.0.
JUNOSe Command Reference Guide Update
113
Advertisement
Table of Contents
