Juniper JUNOSE 10.0.3 - RELEASE NOTES 4-30-2010 Release Note page 86

JUNOSe 10.0.3 Release Notes
Table 4: Routing Protocol Maximums
Feature
BFD
Sessions per line module
ECMP maximum paths to a destination
BGP, IS-IS, MPLS, OSPF, RIP
IPv4 forwarding table entries
(See Note 1 on page 77.)
Chassis with only ASIC modules
IP network interfaces (IPv4 and IPv6)
Per chassis
(See Note 2 on page 77.)
Per line module ASIC
IPv4 routing protocol scaling and peering densities
(See Note 3 on page 77.)
Routing table entries
(See Note 4 on page 77.)
ANCP Adjacency Scaling
(See Note 5 on page 77.)
BGP-4 peering sessions
BGP-4 routes (NLRI)
IP next hops (egress FECs) on router with ASIC modules
(used to represent the IP addresses of next-hop routers
on Ethernet interfaces)
MPLS next hops (egress FECs) on router with ASIC
modules only
MPLS forwarding entries
78
ERX310, ERX7xx, and ERX14xx System Maximums
10. Dynamic values represent typical limits that vary depending on configuration
details and actual dynamic behavior. For dynamic values only, multiple server
modules (SMs) in a chassis can improve the values as long as the multiple
server modules are online and the number of virtual routers configured with
NAT is greater than or equal to the number of server modules. If a server
module fails, the load is redistributed to the remaining server modules, with a
consequent reduction in aggregate capacity.
11. Static and dynamic translations occupy the same table; therefore, the number
of static translation entries present in the table reduces the room for dynamic
entries.
ERX705 and
ERX310 ERX710
50 50
16 16
1,048,576 1,048,576
16,000 32,000
8000 8000
500,000 500,000
5000 5000
1000 1000
1,500,000 1,500,000
1,000,000 1,000,000
500,000 500,000
64,000 64,000
ERX1410 ERX1440
50 50
16 16
1,048,576 1,048,576
32,000 48,000
8000 8000
500,000 500,000
5000 5000
1000 1000
1,500,000 1,500,000
1,000,000 1,000,000
500,000 500,000
64,000 64,000