Table of Contents
Advertisement
Monitoring and maintaining the system
6
If you are using an enterprise system, then add servers to the system and set them online.
•
If you are installing new servers, then see "Installing new servers during recovery" on page 88.
•
If you are using existing servers, then see "Connecting existing servers during recovery" on page 88.
7
If the new load balancer is identified by a new IP address or fully qualified domain name, then do the following:
a
Recreate any printer ports on software clients. For more information, see "Recreating Lexmark Intelligent
Capture printer ports after an address change" on page 89.
b
Change settings for any associated eSF applications that specify the load balancer address using the eSF
Configuration task on the Device Groups tab in LMC. For more information, see "Configuring an eSF application
associated with a solution" on page 93.
Installing new servers during recovery
1
On computers where you want to install servers, make sure the time is synchronized with existing system
components using an NTP server.
2
Perform server installations using the new database and/or load balancer. For more information, see "Installing
servers" on page 38.
3
Install any third‑party services required by installed solutions on each new server.
4
Perform policy updates as necessary:
•
If the new database and load balancer are identified by the same IP address(es) and fully qualified domain
name(s) as the failed database and/or load balancer, then perform a policy update for any device groups that
contain e‑Task printers, making sure to clear the Only update those devices which are Out of Policy check box.
•
If the backup database or load balancer is identified by a new IP address or fully qualified domain name, then
perform a policy update for all device groups, making sure to clear the Only update those devices which are
Out of Policy check box.
5
From the System tab in LMC, set the new servers online. For more information, see "Viewing and changing server
status" on page 56.
6
If new servers are identified by different addresses than the failed servers, then the failed servers remain in the
system and appear as non‑communicating on the System Status page. To avoid affecting system performance,
remove these servers from the System tab in LMC.
Connecting existing servers during recovery
Do the following after the database or load balancer is recovered:
•
If the new database and load balancer are identified by the same IP address(es) and fully qualified domain name(s)
as the failed database and/or load balancer, then do the following:
1
Make sure the time is synchronized among all system components using an NTP server.
2
Restart the Lexmark Solutions Application Server service from the Windows Services control panel on each
server.
3
Perform a policy update for any device groups that contain e‑Task printers, making sure to clear the Only update
those devices which are Out of Policy check box.
4
From the System tab in LMC, set the servers online. For more information, see "Viewing and changing server
status" on page 56.
88
Advertisement
Table of Contents
