Using Kerberos Authentication; Configuring Kerberos Authentication On Printers - Lexmark 634dte - X B/W Laser Administrator's Manual

Installing Lexmark Intelligent Capture
3
Run the batch file again using the appropriate options as shown in the usage instructions.
4
Follow any other instructions in the command prompt window.

Using Kerberos authentication

If a user logs on at a printer using Kerberos, the credentials can be used by the Lexmark Intelligent Capture system to
manipulate files on the network and interact with ECM systems on behalf of the user.
Notes:
•
SSL is required to use Kerberos authentication with an Lexmark Intelligent Capture system, and secure
communication between printers and servers must be enabled for any device group that uses a solution with
Kerberos authentication. For more information, see "Enabling secure communication between servers and
printers in a device group" on page 106.
•
The date and time must be correct on the printer, Lexmark Intelligent Capture server, and KDC server when
using Kerberos authentication.

Configuring Kerberos authentication on printers

Notes:
•
The following procedure applies to e‑Task 2+ printers. If these steps do not apply to your printer, then see the
documentation that came with your printer.
•
The names and locations of some links differ depending on the firmware installed on your printer. Where
multiple link names or locations are specified below, click the specified link that appears for your printer.
1
Type the printer IP address or host name in the address field of your Web browser to access the printer Embedded
Web Server.
Note: If you do not know the IP address or host name of the printer, then you can:
• View the information on the printer control panel home screen, or in the TCP/IP section under the
Networks/Ports menu.
•
Print a network setup page or menu settings page and locate the information in the TCP/IP section.
2
Click Settings > Security > Security Setup.
3
Configure the connection to the Kerberos Domain Controller:
a
In the "Step 1: Configuring a Security Building Block" section, click Kerberos 5.
b
Select a configuration method:
•
To import a Kerberos configuration file, which allows more control over Kerberos tickets, use the Import
Kerberos File section:
1
Click Browse to find the krb5.conf file.
2
Click Submit.
Notes:
–
Click Delete File to remove the Kerberos configuration file from the printer.
–
Click View File to view the Kerberos configuration file for the printer.
41