Table of Contents
Advertisement
Installing Lexmark Intelligent Capture
c
Open a command prompt window as an administrator.
1
Click Start > All Programs > Accessories.
2
Right-click Command prompt, and then click Run as administrator.
3
If the User Account Control dialog appears, then confirm that you want to start the command prompt as an
administrator, and then click Continue.
d
From the command prompt window, change the current directory to the temporary directory you created.
e
Run the VBScript file by typing cscript LexmarkSolutionsClusterConfigScript.vbs and then
pressing Enter.
2
Click Yes to begin the installation.
3
Enter a number to select a resource group as shown in the dialog, and then click OK.
4
Enter a number to select an IP address for the logical host as shown in the dialog, and then click OK.
5
Allow the installation to complete, and then click OK.
The configured cluster contains the necessary Lexmark services.
Installing servers
Note: Multiple servers should not be installed at the same time. Complete each server installation before beginning
another one.
Do the following on each computer that will run a server:
1
If the Lexmark Solutions installation window is not open, then run Setup.exe from the installation package.
2
From the Lexmark Solutions installation window, click Install Enterprise System > Install Server.
3
Click Agree to accept the license agreement.
4
If necessary, specify a location for the installation, and then click Next.
5
If the computer contains multiple network adapters, then select the IP address to bind to the installed server.
6
If you want to use only IP addresses for a system without reliable DNS, then select IP address only install, and then
click Next.
7
Type the fully qualified domain name or IP address of the computer or cluster logical host where the database is
installed.
Notes:
•
If you are installing the server on the same computer as the database and/or the load balancer, then you
must still use the fully qualified domain name or IP address of the computer on the network. Do not use
localhost or the loopback IP address (127.0.0.1) for the location of the database or load balancer.
•
If you are using DNS aliases for connection to a backup system during a recovery, then use the DNS aliases of
the database and load balancer.
38
Advertisement
Table of Contents
