Table of Contents
Advertisement
Installing Lexmark Intelligent Capture
Installing the database and load balancer without clustering (configurations 1,
1‑N, and 1‑1‑N)
Installing the database
Note: If you are installing an Oracle database, then do not install the default database.
Do the following on the computer that will run the database:
1
From the installation package, run Setup.exe.
2
From the Lexmark Solutions installation window, click Install Enterprise System > Install Database.
3
Click Agree to accept the license agreement.
4
If necessary, specify a location for the installation, and then click Next.
Note: The installation path cannot contain double‑byte characters.
5
Select the IP address of the computer that will run the database.
6
If you want to use only IP addresses for a system without reliable DNS, then select IP address only install, and then
click Next.
7
If you are installing a system to recover a backup, then do the following:
a
Select Restore Install (RI).
b
Type the path of the folder containing the .ri file from the backup, or click the folder icon, and then locate the .ri
file.
8
Click Finish.
9
Allow the installation to complete, and then click Done.
Installing the load balancer
Do the following on the computer that will run the load balancer:
1
If the Lexmark Solutions installation window is not open, then run Setup.exe from the installation package.
2
From the Lexmark Solutions installation window, click Install Enterprise System > Install Load Balancer.
3
Click Agree to accept the license agreement.
4
If necessary, specify a location for the installation, and then click Next.
Note: The installation path cannot contain double‑byte characters.
5
Select the IP address of the computer that will run the load balancer.
6
If you want to use only IP addresses for a system without reliable DNS, then select IP address only install, and then
click Next.
7
Type the fully qualified domain name or IP address of the computer where the database is installed.
Notes:
•
If you are installing the load balancer on the same computer as the database, then you must still use the
fully qualified domain name or IP address of the computer on the network. Do not use localhost or the
loopback IP address (127.0.0.1) for the location of the database.
•
When installing any configuration other than configuration 1, the location of the database can be set most
conveniently during installation. If the database is moved, or the IP address of the database changes for any
34
Advertisement
Table of Contents
