Sort Copy; Rotate Copy - Kyocera KM-1530 Instruction Handbook Manual

4. Sort copy

Copies can be sorted into the required number of sets by storing
original images in the memory before performing copying.
* Sort copying requires the optional memory board.
NOTE
Rotate sort
If "ON" is selected for "Rotate sort" (see page 6-6) and 11" x 8 1/2"
paper is used, the orientation of each set of copies can be changed
for easy sorting. To use this setting, 11" x 8 1/2" paper must be set in
the copier drawer and an optional drawer.
1
Set the original(s).
2
Press the Sort key to light the indicator.

5. Rotate copy

Even if the orientation of the original is different from that of paper in
the drawer, copying will be performed by rotating the image 90
degrees counter-clockwise. No setting is required for this function.
* Rotate copying requires the optional memory board.
NOTE
If "Sort ON" is selected for "Output mode" (see page 6-6), the sort
indicator is lit and the copier is in the sort mode. If "Sort OFF" is
selected, press the sort key to light the indicator. If originals are set in
the optional DF, the Sort indicator lights and the copier enters the sort
mode.
3
Enter the number of copies to be made and press the Start
key.
* When originals are set in the DF, all originals are scanned
one by one and copying performed accordingly.
* When setting the originals on the platen, "1" (number of
scanned originals) will be displayed after the first original is
scanned. Replace the original and press the Start key.
Repeat the same procedure for all the originals to be
copied.
4
When scanning of all the originals ends, press the enter key
or Sort key. Copying will start.
NOTE
• The sizes of the original and copy paper available for rotate copying
in the auto paper selection mode are limited to 8 1/2" x 11" and 11" x
8 1/2".
• The sizes of the copy paper available for rotate copying in the auto
magnification selection mode are limited to 8 1/2" x 11", 11" x 8 1/2",
and 8 1/2" x 5 1/2".
CHAPTER 5 FUNCTIONS
5-6