Kyocera KM-1530 Instruction Handbook Manual page 16

CHAPTER 3 PREPARATIONS BEFORE USE
IMPORTANT
When copying onto thick paper or transparencies, press the Transpar-
ency key to light the indicator.
* When using transparencies or thick paper, select "Transparencies"
or "Thick paper" in the "Transparency mode" (see page 6-6) of the
default settings.
2
Adjust the insert guides to the size of the paper to be loaded.
* When loading paper that is longer than 8 1/2" x 11", pull out
the support guide.
3-3
3
Insert the paper along the guides as far as it will go.
IMPORTANT
When loading paper into the multi-bypass, make sure that the copy
side is facing downward. (The copy side is the side facing upward
when the package is opened.)
If the leading edge of the paper is curled, straighten it out before
loading the paper in the multi-bypass.
Setting the paper size for the multi-bypass
If a paper size is set for the multi-bypass, the multi-bypass may be
automatically selected in the auto paper selection mode depending on
the original size.
* For how to set non-standard size paper width for the multi-bypass
for the paper selection, see default code F13 in Default Settings in
COPIER MANAGEMENT on page 6-6.
Press and hold the Paper Select key for 3 seconds. The
1
indicator for the size of the paper currently loaded in the
multi-bypass lights. "F12" appears on the copy quantity
display and, 2 seconds later, a number appears.
The number displayed indicates the paper size as follows:
1: 11" x 17"
2: 8 1/2" x 14"
3: 8 2/1" x 11"
4: 5 1/2" x 8 1/2"
5: 11" x 8 1/2"
6: U (no size setting)
xxx: Setting of non-standard size paper width for multi-
bypass