Configuring Igmp Snooping - Fujitsu XG700 - Switch User Manual

XG700 User's Guide

4.9.5 Configuring IGMP Snooping

To configure IGMP snooping, carry out the following procedure in the administrator EXEC mode.
xg# configure terminal
xg(config)# ip snooping protocol igmp
xg(config)# ip snooping vlan <1-4094>
xg(config)# ip snooping vlan <1-4094>
group-member-interval <60-600>
xg(config)# ip snooping vlan <1-4094>
mrouter { port <1-12> | agg-port <1-6> }
xg(config)# ip snooping vlan <1-4094>
mrouter suppress-learning
xg(config)# ip snooping vlan <1-4094>
last-member-interval <1-9>
xg(config)# ip snooping vlan <1-4094>
send-query-count <1-3>
xg(config)# ip snooping vlan
max-group <10-128>
xg(config)# ip snooping vlan <1-4094>
fast-leave
xg(config)# exit
To enable IGMP query, carry out the following procedure in the administrator EXEC mode.
xg# configure terminal
xg(config)# ip snooping protocol igmp
xg(config)# ip snooping vlan <1-4094>
xg(config)# ip snooping vlan <1-4094>
group-member-interval <60-600>
xg(config)# ip snooping vlan <1-4094>
last-member-interval <1-9>
xg(config)# ip snooping vlan <1-4094>
send-query-count <1-3>
xg(config)# ip snooping vlan <1-4094>
querier ip A.B.C.D
xg(config)# exit
Command
Command
52/266
All Rights Reserved, Copyright (C) PFU LIMITED 2005-2006
Switch to global configuration mode.
Enable global IGMP snooping on the XG700.
Enable IGMP snooping for each VLAN separately.
(Optional)
Change the group member interval.
(Optional)
Register a port on which a multicast router resides statically.
(Optional)
Suppress dynamic registration of port on which a multicast
router resides.
(Optional)
Change the last member interval.
(Optional)
Change the frequency at which a Query message is sent.
(Optional)
Change the number of multicast addresses that can be
registered with IGMP snooping for each VLAN.
(Optional)
Set the fast-leave mode used when receiving an IGMP Leave
message.
Exit to administrator EXEC mode.
Switch to global configuration mode.
Enable global IGMP snooping on the XG700.
Enable IGMP snooping for each VLAN separately.
(Optional)
Change the group member interval.
(Optional)
Change the last member interval.
(Optional)
Change the frequency at which a Query message is sent.
Enable IGMP query and set the source IP address for a Query
message.
Exit to administrator EXEC mode.
Task
Task