Table of Contents
Advertisement
XG700 User's Guide
5.2 Management LAN Interface Configuration Commands
This section explains configuration commands related to the Management LAN Interface.
5.2.1 management-lan ip
Function
Sets the IP address and default gateway, when the Management LAN Interface is used.
Use the no form to disable the Management LAN Interface.
Prompt
xg(config)#
Command syntax
management-lan ip A.B.C.D/M [default-gw A.B.C.D]
no management-lan ip
Parameter
ip A.B.C.D/M
Specifies the IP address and subnet mask bit length of the Management LAN Interface in the A.B.C.D/M format.
Specifies an IP address to A.B.C.D, and a subnet mask bit length to M.
IP addresses that can be set are: 1.0.0.1 - 126.255.255.254, 128.0.0.1 - 191.255.255.254, and 192.0.0.1 -
223.255.255.254.
default-gw A.B.C.D
Specifies the IP address of the default gateway.
Command type
Configuration command
Default
None
Message
% Invalid IP-address.
Explanation
The specified format of the IP address or specified content is incorrect.
Solution
Specify the IP address in a correct format and execute it again.
Note
When the IP address is changed from a telnet terminal using this command, telnet connection will be disconnected.
Connect again with a new address.
Example
Make the Management LAN Interface usable by setting IP address to "12.34.56.25," subnet mask bit length to "24"
(255.255.255.0), and default gateway address to "12.34.56.1".
xg(config)# management-lan ip 12.34.56.25/24 default-gw 12.34.56.1
58/266
All Rights Reserved, Copyright (C) PFU LIMITED 2005-2006
Advertisement
Table of Contents
