Kernel (Layer 2 Basic Control: 2000-2999) - Fujitsu XG700 - Switch User Manual

XG700 User's Guide
Message ID
Severity
S1900
CRITICAL
S1950
CRITICAL
S1951
CRITICAL
A.2.3

kernel (Layer 2 Basic Control: 2000-2999)

Message
IDSeverity
P2000
CRITICAL
P2001
CRITICAL
P2002
CRITICAL
P2003
CRITICAL
P2004
CRITICAL
S2005
CRITICAL
Core dumped %1$
Explanation
A critical firmware error was detected and process dump output.
[[Inserted string]]%1$: Process number
Solution
Obtain maintenance information using the
content before contacting the XG700 sales representative.
Oops: %1$, sig: %2$
Explanation
An unhandled exception caused a system panic.
[[Inserted string]]%1$: Details about error
[[Inserted string]]%2$: Signal number
Solution
Note this message and those displayed above and below it and contact your XG700 sales representative. This
message may not be recorded in the log.
Kernel panic: %1$
Explanation
The software detected a status error during processing and raised a system panic.
[[Inserted string]]%1$: Details about error
Solution
Note this message and those displayed above and below it and contact your XG700 sales representative. This
message may not be recorded in the log.
Can't allocate network device structure.
Explanation
Failed to allocate the control area for the switch chip.
Solution
Note the message contents and contact your XG700 sales representative.
Can't allocate h/w private structure.
Explanation
Failed to allocate the control area for the switch chip.
Solution
Note the message contents and contact your XG700 sales representative.
Failed to Memory Map.
Explanation
Failed to map memory for the switch chip.
Solution
Note the message contents and contact your XG700 sales representative.
Unsupported Switch Chip or Not Found : 0x%1$
Explanation
Failed to detect the switch chip.
[[Inserted string]]%1$: Displays supplementary code for the error.
Solution
Note the message contents and contact your XG700 sales representative.
Buffer Configuration is done by Jumper.
Explanation
An error was detected in the switch chip configuration.
Solution
Note the message contents and contact your XG700 sales representative.
Failed to BIST.
Explanation
A fault was detected during the switch chip self-test.
Solution
Note the message contents and contact your XG700 sales representative.
All Rights Reserved, Copyright (C) PFU LIMITED 2005-2006
Message/Explanation/Solution
"tftp put-maintanace" command and then take a note of the message
Message/Explanation/Solution
235/266