Table of Contents
Advertisement
XG700 User's Guide
5.10.8 spanning-tree port-priority
Function
Sets a port priority of the Spanning Tree.
A smaller value has a higher priority.
Use the no form to return to the default setup.
Prompt
xg(config-if)# ,or xg(config-agg)#
Command syntax
spanning-tree port-priority <0-240>
no spanning-tree port-priority
Parameter
port-priority <0-240>
Sets a port priority of the Spanning Tree. Specify the set value as integer multiplied by 16. It can be within the range of
0 to 240.
Command type
Configuration command
Default
128
Message
% Priority is not step of 16
Explanation
The priority is not an integer multiplied by 16.
Solution
Define the priority using an integer multiplied by 16.
Example
Set the priority of port2 to 160.
xg(config)# interface port 2
xg(config-if)# spanning-tree port-priority 160
137/266
All Rights Reserved, Copyright (C) PFU LIMITED 2005-2006
Advertisement
Table of Contents
